Alba 8A - Fig. 2-9 - Coupling with a Safety Lock

8A-16A-32A INSTALLATION Page 13 of 28
8A-16A-32A Rev.00-EN  (+34) 944 71 16 00  (+34) 944 53 17 54  export@alba.es www.alba.es
Fig. 2-9 – Coupling with a safety lock
In order to attach or remove the coupling device (eyelet, grommet, thimble, etc.) you need to
press the safety lock into the coupling, whereby it will return to its original position
automatically when the operation has been concluded.
If the load is equipped with one or more specific dragging and/or lifting points, the cable
coupling will need to be placed, directly or using a sling, on these points, always taking the
stability of the load into account when moving it.
If the load has no specific dragging and/or lifting points, it will need to be tied to the cable
coupling using slings, taking care not to damage it and taking the stability of the load into
account when moving it.
WARNING:
Never use the traction apparatus cable to secure or sling loads.
WARNING:
The coupling safety lock should not be off when the load is being
moved.
WARNING:
The load should be correctly tethered and secured before starting
to move it.
Safety lock