8A-16A-32A MAINTENANCE Page 24 of 28
8A-16A-32A Rev.00-EN (+34) 944 71 16 00 (+34) 944 53 17 54 export@alba.es www.alba.es
5.3 Locating and dealing with faults
FAULT CAUSES SOLUTION
The Cable is stuck in the
mechanism of the Traction
Apparatus
The Cable is in poor
condition.
Replace the Cable with a
new original.
The Cable used is not an
original ALBA cable and is
unsuitable for the operation
The levers are more difficult
to move, or are behaving
strangely
The Apparatus has not been
oiled correctly
Lubricate the Traction
Apparatus using SAE 90 or
SAE 140 oil
The Up lever moves freely The safety screw protecting
against overloading is broken
Replace the safety screw
with a new original.
The load shakes when
lowering
Inadequately greased
Traction Apparatus
To deal with this problem the
Traction Apparatus should
be greased while engaging
the up or down lever in order
to facilitate the oiling of the
parts.
WARNING:
The solutions provided in the table above are of a general nature.
The detailed procedure to be followed is set forth in the respective
chapters of this instructions manual.
To Next Page
Loading...