8A-16A-32A SEGURIDAD pág. 18 de 28
8A-16A-32A Rev.00-EN
(+34) 944 71 16 00 (+34) 944 53 17 54 export@alba.es
www.alba.es
Fig. 4-1 – Safety screw
In the event the safety screw breaks, the Traction Apparatus will be prevented from lifting
and the following steps should then be taken:
Guarantee the safety of the load.
Unhook the Apparatus.
When you are sure there is no risk involved in the operation, replace the broken
safety screw with an identical original.
The cause of the overloading needs to be ascertained before using the Traction
Apparatus again. The appropriate pulleys or a traction device with a greater
capacity can be used for this purpose.
WARNING:
In the event the safety screw breaks, never replace it with one othe
than the type supplied. The use of any other type of safety scre
implies “unknown” behaviour in relation to overloading, with all the
consequences this might involve. Contact your retailer or manufacture
for spare parts.
Safety screw
To Next Page
Loading...