48 English
SELECT STEP FREQUENCY
You can change the steps of VHF-Low, FM, Aircraft, VHF-High and UHF bank.
1. Press (Srvc) until a bank you want to change appears.
2. Press (Stp) until a step mode appears.
3. 9/,'(),'XKY'(#'/,<,0('/(,5/'"*#3'M$(#'K'E1C'K']1=E'K'DC1C'K'D=1E'B^_'`2),'a(,5'"#*'
Aircraft bank is 8.33 or 12.5 kHz.)
4. Press (Clr) or (Stp) or wait for 2 seconds to return to the mode you were in.
LOCKOUT PREPROGRAMMED FREQUENCY
G#$'0.%'/B-5'$5'(#'bC'/5,0-6,&'"*,8$,%0-,/'&$*-%+'.'a,*L-0,'/0.%1'2)-/'<,(/'?#$'.L#-&'
unwanted frequencies in Service Scan Mode.
To skip a frequency
! Press (L/O) when the scanner stops on the frequency in Service Scan Mode or
when you have selected frequency manually in Service scan hold mode. L/O
appears.
To cancel skip for a single frequency
! Manually select the frequency, then (L/O). L/O disappears.
To cancel all skip frequencies
! Press (Hold) to stop scanning in Service scan hold mode, then press & hold (L/O). A
0#%6*3.(-#%'(#%,'/#$%&/1
LOCKOUT FAVOURITE CHANNEL
You can increase the scanning speed by locking out channels that you do not like or which
have a continuous transmission for all the channels in favourite channel memory.
To lock out a channel
! Manually select the channel, then press (L/O). L/O appears.
Note:#N"B#8+$#0%'))#&+$B+))3#0,),8%#)"87,*G"B%#89+$$,)0<
To remove the lockout from a channel
! Manually select the channel, then press (L/O). L/O disappears.
OPERATION
To Next Page
Loading...
