Alcatel-Lucent 7330 - Page 221

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-21
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Table 5-8 SIP protocol parameters
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 and CLI
parameters
transport_pr
otocol
(1)
The name (UDP, TCP, TLS) of the
transport protocol and the port
number to be used for signaling. This is
an optional parameter, the default
protocol value is UDP and the default
port number is 5060. UDP is the only
allowed value for transport protocol.
(This parameter does not apply to
iConfig message transport.)
For package C and D ONTs, UDP is used
without any configuration necessary.
YYPackage
A, B, H
only
Yes
Default is
UDP
TL1 using UDPPort
using
ent-ontsip-config
C L I u s i n g u d p - p o r t
using configure
voice ont
sip-config
registrar_uri
(1)
The uniform resource identifier (URI) is
used as the request URI for all
REGISTER requests. This is a string of
up to 99 characters and is a required
parameter. The FTP XML name of this
parameter is shown as RegistrarURI.
Can use the form sip:domain or
sip:registrar_route
YYAll
except
package
C and D
Yes TL1 using
PROXYSERVPROFID
using
ent-ontsip-config
CLI using
proxyserv-prof
using configure
voice ont
sip-config
registrar_ro
ute
(1)
The address of the server or proxy to
which REGISTER requests are sent. It is
a numeric IP address or a fully qualified
domain name. This is a string of up to
99 characters and is a required
parameter. The FTP XML name of this
parameter is shown as RegistrarRoute.
When the string dhcp is used, this
keyword substitutes the IP address or
domain name returned from DHCP
option 120 instead of the
registrar_route parameter value. If the
DHCP server does not provide an option
120 value, a 0.0.0.0 address is
substituted and a registration failure
alarm is raised for each configured
POTS line.
Can use the form xxx.xxx.xxx.xxx:port,
where xxx.xxx.xxx.xxx is the IP address
and port is the port number from
transport_protocol
YYAll Yes, but
registrar
address
and
registrar
route will
have the
same
address.
TL1 using
REGISTRARPROFID
and
REGISTRARPROFN
M using
ent-ontsip-config
CLI using
registrar-prof
using configure
voice ont
sip-config
register_per
iod
(1)
The registration expiration time that
the client will propose by including it in
an Expires header of a REGISTER
request. This is a non-negative integer
and the value is expressed in seconds.
The default value is 3600.
YYAll Yes TL1 using
REGEXPTIME using
ent-ontsip-config
CLI using
reg-expire-time
using
configure voice
ont sip-config
(1 of 4)