Alcatel-Lucent 7330 - Page 222

5 — VoIP overview
5-22 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
register_hea
d_start
(1)
The number of seconds prior to
expiration of a registration at which
the client sends a REGISTER request to
refresh the registration. This is a
non-negative integer and the value is
expressed in seconds. The default
value is 60.
YYAll Yes,
default
value in
TL1 and
CLI is 360
seconds.
TL1 using
REREGHEADSTRT
using
ent-ontsip-config
CLI using
re-reg-head-start
using
configure voice
ont sip-config
register_retr
y_interval
(1)
The interval between successive
registration retries after a failed
registration retry. The value is
expressed in seconds. The range is zero
(0) to 65535 and zero (0) disables
registration. The default value is 60.
Y Y All No, value
is derived
from
FTP/defau
lt line
profile.
N/A
outbound_pr
oxy
(1)
The address of a server or proxy to
which all SIP requests are to be sent,
except for those for which a server of
proxy is not otherwise specified. It is
either a numeric IP address or a fully
qualified domain name. This is a string
of up to 99 characters and is a required
parameter. The FTP XML name of this
parameter is shown as OutboundProxy.
When the string dhcp is used, this
keyword substitutes the IP address or
domain name returned from DHCP
option 120 instead of the
registrar_route parameter value. If the
DHCP server does not provide an option
120 value, a 0.0.0.0 address is
substituted and invite failure and
subscribe failure alarms are raised for
each configured POTS line.
The outbound_proxy value is
superseded for INVITE requests if the
outbound_uri_suffix value is
configured.
• outbound_uri_prefix
(1)
+ dialed
number + @ + outbound_proxy
when the oubound_uri_suffix value
is not configured
• outbound_uri_prefix
(1)
+ dialed
number + outbound_uri_suffix
when the oubound_uri_suffix value
is configured
YYAll Yes, TL1
and CLI
allows SIP
URI for
outbound
proxy but
the ONT
expects a
string in a
non-URI
format.
TL1 using
OUTPROXYSERVER
PROFID using
ent-ontsip-config
CLI using
outproxyserv-prof
using
configure voice
ont sip-config
sip_dscp
(1)
The differentiated services code point
(DSCP) value that should populate the
DS field of SIP packets sent by the user
agent. It is an integer value in the
range of zero (0) to 63. The default
value is the value configured via
SNMP/TL1.
YYPackage
A, B, H
only
Yes TL1 using DSCP
using
ent-ontsip-config
C L I u s i n g d s c p
using
configure voice
ont sip-config
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 and CLI
parameters
(2 of 4)