Alcatel-Lucent 7330 - Page 223

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-23
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
subscribe_p
eriod
(1)
The subscription expiration time that
the client will propose by including it in
an Expires header of a SUBSCRIBE
request. This is a non-negative integer
and the value is expressed in
seconds.The default value is 86400
(one day). (This parameter does not
apply to iConfig requests.)
NYPackage
A, B, H
only
Yes, TL1
and CLI
default is
3600 but
XML
default is
85400
TL1 using
VOICEMAILTO
using
ed-ontvoiceportsi
p
CLI using
voice-mail-to
using
configure voice
ont voice-sip-port
subscribe_h
ead_start
(1)
The number of seconds prior to
expiration of a subscription at which
the client sends a SUBSCRIBE request
to refresh the subscription.This is a
non-negative integer and the value is
expressed in seconds. The default
value is 3600 (one hour).
NYPackage
A, B, H
only
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
sip_timer_t1
(1)
The value of the SIP T1 timer (the
round-trip time estimate). This is a
non-negative integer and the value is
expressed in milliseconds. The range is
1 to 65535. The default value is 500.
YYPackage
A, B, H
only
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
sip_timer_t2
(1)
The value of the SIP T2 timer (the
maximum retry interval for a
non-INVITE request). This is an integer
and the value is expressed in seconds.
The range is 1 to 65535. The default is
4.
YYPackage
A, B, H
only
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
sip_invite_ti
meout
(1)
The INVITE transaction timeout,
designated as Timer B in RFC 3261. This
is an integer. The value is expressed in
seconds. The range is 1 to 65535. The
default value is 32 (64*T1).
YYPackage
A, B, H
only
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
sip_noninvit
e_timeout
(1
)
The non-INVITE transaction timeout,
designated as Timer F in RFC 3261. This
is an integer and the value is expressed
in seconds. The range is 1 to 65535.
The default value is 32 (64*T1).
YYPackage
A, B, H
only
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
default_pro
duct_id
Specifies the application server
product identifier that shall be
assumed for product-specific
communication with the application
server if the application server does
not provide a product identifier. The
value of this parameter is any string
that can be used as the value of a
server or user agent header. The
default is an empty string.
YYAll
except
package
C, D,
and E
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 and CLI
parameters
(3 of 4)