Alcatel-Lucent 7330 - Page 224

5 — VoIP overview
5-24 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
Note
(1)
This parameter can only be set on an ONT-wide basis when the parameter is configured as part of the configuration profile
(FTP download).
Identity data
Table 5-9 lists the identity data. When OMCIv2 support is yes, then TL1 can be used
to configure equivalent parameters on systems supporting OMCIv2.
peer_codec
_commit
Specifies the behavior of the ONT SIP
client software as to whether a
re-invite message is sent at the end of
an SDP negotiation. The value of this
parameter is a string with values:
• (default) always to ensure the ONT
send the re-invite message when
multiple codecs are included
• none to ensure the ONT never
sends a re-invite message
• single to ensure the ONT sends the
re-invite message except when the
SDP answer contains a single codec
The default is set to none when running
in iConfig SIP mode in voice R4.3
YYAll
except
package
C, D,
and E
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
add_route_h
eader
Specifies whether the ONT adds route
headers to outgoing requests. The
options are:
• true (default)
• false
When set to true, the route header are
added based on the reg_route
parameter for register requests and
the outbound_proxy parameter for all
other requests.
When set to false, no route header is
added to outgoing requests that would
initiate a new dialog.
YYAll
except
package
C, D,
and E
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
enable_reg_
subscribe
Specifies whether the ONT should send
the registration subscribe method
described in RFC3680. The options are:
• true
• false (default)
All
except
package
C, D,
and E
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 and CLI
parameters
(4 of 4)