Alcatel-Lucent 7330 - Page 228

5 — VoIP overview
5-28 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
enter_key The digit that is to be treated as an
indication that dialing is complete,
when received at a point in digit
collection where it does not match the
dialing pattern at that point. This is
typically used to signal the completion
of dialing a speed dialing number or an
international number. This is an
optional parameter. The hash mark
symbol “#” is the default value.
Other devices always use #.
YYPackage
A, B, H
only
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
resanswer_timer Specifies the reanswer timer.
The default value is a string
use_timed_release. You can also use a
non-negative integer to indicate the
reanswer timer value. A value of 0
causes the user agent to send a BYE
immediately upon on-hook.
In the case of an integer, the timer
governs the following behavior. On an
inbound call, if the analog line goes
on-hook, the User Agent maintains the
dialog and start the reanswer_timer.
The media session remains active with
the user agent transmitting RTCP
packets as usual, and silence if the
current audio format requires, and
receiving audio.
If the analog line goes off-hook before
the timer expires, the analog line
resumes participation in the media
session of the dialog, and the timer is
canceled. If a BYE is received before
the timer expires, the user agent idles
the analog line and cancel the timer.
If the timer expires with the line
remaining on-hook, the User Agent
idles the line and end the dialog by
sending a BYE. A value of 0 will cause
the User Agent to send BYE
immediately upon on-hook.
N Y All
except
package
C, D,
and E
No, value
is derived
from
timed_rel
ease XML
value
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(2 of 3)