Alcatel-Lucent 7330 - Page 229

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-29
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Media local network profile
Table 5-11 lists the media local network profile parameters. When OMCIv2 support
is yes, then TL1 can be used to configure equivalent parameters on systems
supporting OMCIv2.
error_tone_time
r
This parameter is a string containing
either a non-negative integer value or
the text use_timed_release. The
options are used_timed_released
(default) and a non-zero integer.
If the parameter has an integer value
then the value governs the time, in
seconds, that tones are generated in
response to INVITE errors before
starting permanent signal treatment.
If the parameter is set to
use_timed_release timed_release
parameter has a value of 0, the timer
is set to 10 seconds. If the
use_time_release value is used, then
BUSY is the only error condition whose
duration is governed by the
timed_release. All other errors will
result in immediate permanent signal
treatment.
N Y All
except
package
C, D,
and E
No, value
is derived
from
timed_rel
ease XML
value
N/A
auto_connect_ti
mer
This parameter is a string containing
either a non-negative integer value or
the text use_timed_release. If this
parameter has an integer value it will
govern how long the device waits
before resuming a held remote call
when an active remote call goes
on-hook. If the value use_time_release
is selected and the timed_release
parameter has a value of 0, this timer
is set to 10 seconds.
N Y All
except
package
C, D,
and E
No, value
is derived
from
timed_rel
ease XML
value
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(3 of 3)