Alcatel-Lucent 7330 - Page 233

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-33
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Service data set
Table 5-12 lists the service parameters per port. When OMCIv2 support is yes, then
TL1 can be used to configure equivalent parameters on systems supporting OMCIv2.
Table 5-12 Service data provisioning parameters per port
dtmf_volume_le
vel
Specifies the volume field sent in the
RFC 2833 packets that encode DTMF
from the attached phone. When the
parameter is set to measured, then the
volume of the tone received in dBm0
from the attached phone will be
reported in the RFC 2833 packets.
When the parameter is set to an
integer between 0 and 55, then that
value will be used in the volume field
of any transmitted RTC 2833 packets
signaling DTMF. The default is
measured.
N Y All
except
package
C, D,
and E
No, value
is derived
from
FTP/defau
lt line
profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameter
(4 of 4)
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
digit_map A pattern that guides digit
collection and allows the user
agent to determine when dialing is
complete. One digit_map setting is
supported for each POTS port. See
Table 5-14 for a description of the
digit map contents. This is a string
of up to 1093 characters and is a
required parameter with no
default value. A digit map must be
customized for each SIP
implementation based on the
features of the SIP server in the
network.
White space in the digit map string
is not significant. Characters are
case insensitive.
YYAll Yes but no
TL1 or CLI
developed
Value is
derived
from
FTP/default
line profile.
N/A
(1 of 23)