Alcatel-Lucent 7330 - Page 241

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-41
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
mwi_reminder_burst The duration of the
message-waiting reminder ring
burst. This is an optional
parameter. This is an integer
expressed in milliseconds. The
default value is 500.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
mwi_reminder_inter
val
The duration of the interval
between message-waiting
reminder ring bursts. This is an
optional parameter. This is a
non-negative integer expressed in
minutes. The default value is 15.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
bridged_line_uri The bridged line agent URI if the
bridged line service is enabled. If
this property is not set, the user
agent does not enable the POTS
line to act as one of a set of
bridged lines.
YYPackage
A, B, H
only
Yes TL1 using
BRIDGEURIPR
OFID using
ent-profile-v
oipappservic
e
CLI using
b r id g e - p r o f
using
configure
voice ont
voip-app-serv
ice
bridged_line_dialog
_uri
The bridged line dialog URI used by
the bridged line service. If this
property is not set, the user agent
uses the bridged_line_uri setting
as the bridged line dialog URI.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
cfwd_state Indicates whether the state of the
network-based call forwarding
service is to be rendered to the
user.This is a string containing a
value of “yes” or “no.” The default
value is “no.”
YYPackage
A, B, H
only
Yes TL1 using
CALLPRESENT
set to 8 using
ent-profile-v
oipappservic
e
CLI using
call-fwd-indi
cate
using
configure
voice ont
voip-app-serv
ice
cfwd_reminder Indicates whether a reminder alert
is to be provided to the user when
the network-based call forwarding
service redirects a call. This is a
string containing a value of “yes”
or “no.” The default value is “no.”
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
cfwd_event_uri The URI to which a call forwarding
event subscription is sent. If this
property is not set, but either
cfwd_state or cfwd_reminder is set
to “yes,” the call forwarding event
subscription is sent to the URI
specified in the address_of_record
property. This value is a URI.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(9 of 23)