Alcatel-Lucent 7330 - Page 240

5 — VoIP overview
5-40 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
message_event_uri The URI to which a subscription for
message-waiting events is sent. If
this property is not set, the user
agent shall not subscribe for
message waiting events. This value
is a URI The default is no URI,
which disables subscribe. When
the parameter is set to URI, you
can configure the
allow_unmatched_notify
parameter.
When the string autofill is used,
this keyword substitutes a new
message_event_uri value based on
the filled value, after any derived
value, of the address_of_record
parameter.
For other devices, the value is an
empty string and cannot be
changed.
NYPackage
A, B, H
only
Yes TL1 using
VOICEMAIL
using
ed-ontvoicep
ortsip
CLI using
voice-mail-pr
o f u si n g
configure
voice ont
voice-sip-por
t
message_waiting_m
ode
The mode for presenting a
message-waiting indication to the
user. This is a sequence of up to
three values: “dial-tone” to enable
stutter dial tone, “visual” to
enable visual MWI, and
“reminder-ring” to enable a
reminder ring. Any combination of
the three may be specified. This is
an optional parameter. The
default value is “dial-tone.”
You can specify more than one
value at a time in the XML file.
Separate the values using spaces.
YYAll
except
package
C, D,
and E
Yes TL1 using
CALLPRESENT
set to 7 using
ent-profile-v
oipappservic
e
CLI using
mwi-splash-ri
ng,
mwi-spl-dialt
one,
mwi-visual-in
di
using
configure
voice ont
voip-app-serv
ice
vmwi_refresh_interv
al
The duration, in minutes, of the
interval between successive
“refresh” transmissions of the
message-waiting status to the
analog line, if “visual” is specified
in message_waiting_mode. If the
value of this property is zero,
“refresh” transmissions will not be
performed. This is an optional
parameter. This is a non-negative
integer expressed in minutes. The
default value is 30.
YYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
vmwi_abbreviated_r
ing
Indicates whether the abbreviated
ring option is enabled. This is a
string containing a value of “yes”
or “no.” This is an optional
parameter. The default value is
“no.”
For other devices the value is no
and cannot be changed.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(8 of 23)