Alcatel-Lucent 7330 - Page 239

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-39
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
enable_forced_hold Indicates whether the forced hold
behavior is enabled for an
emergency call. This is a string
containing a value of “yes” or
“no.” This is an optional
parameter. The default value is
“no.”
N Y All
except
package
C, D,
and E
Yes TL1 using
CALLPROGTR
AN set to 40
using
ent-profile-v
oipappservic
e
CLI using
emer-ser-org
-hold
using
configure
voice ont
voip-app-serv
ice
supp_ring_offhook_t
imer
The time interval within which the
device must go offhook for a
suppressed ringing call. This is a
non-negative integer. The value is
expressed in seconds. The default
value is 5.
NYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
supp_ring_interrupt
_timer
The time interval within which the
device must go onhook if a
suppressed ringing call is
interrupted. This is a non-negative
integer. The value is expressed in
seconds. The default value is 2.
NYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
conference_uri The URI of the conference server
to be used for the 6-way
conference service.
NYPackage
A, B, H
only
Yes TL1 using
CONFURIPRO
FID using
ent-profile-v
oipappservic
e
CLI using
conf-prof
using
configure
voice ont
voip-app-serv
ice
direct_connect_uri The URI to be inserted as the To
address of an INVITE sent in
response to the device going
off-hook. If this property is set, an
off-hook event triggers an
immediate INVITE with the value of
this property as the To address. If
this property is not set, an off-hook
event provides the dial tone to the
port, allowing the user to dial a
call in the usual manner. This is a
string of up to 99 characters and is
an optional parameter. The
default value is a null string, which
indicates no direct connect. Set
the enable_warmline parameter to
“yes” to use the
direct_connect_uri parameter.
YYAll Yes TL1 using
DIRCONNURIP
PROFID using
ent-profile-v
oipappservic
e
CLI using
dir-conn-prof
using
configure
voice ont
voip-app-serv
ice
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(7 of 23)