Alcatel-Lucent 7330 - Page 248

5 — VoIP overview
5-48 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
etsi_3wc_split This parameter contains the
service code that takes a 3wc to a
consult call state in the ETSI mode.
If this parameter is not configured
or is configured to contain the
empty string, the ONT disables the
split call operation for the line in
question.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or '#'.
An invalid value causes the ONT to
act as if this parameter was not
configured. This parameter only
has meaning if the enable_esti
parameter is set to “yes”. The
default is an empty string.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_cw_release This parameter contains the
service code used to release the
active session and resume the held
call as a two way call ending the
call waiting state. If this
parameter is not configured or is
configured to contain the empty
string, the ONT disables the
release active session operation
for the line in question.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or '#'.
An invalid value causes the ONT to
act as if this parameter was not
configured. This parameter only
has meaning if the enable_esti
parameter is set to “yes”. The
default is an empty string.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_cw_toggle This parameter contains the
service code to be used to toggle
between sessions during call
waiting. If this parameter is not
configured or is configured to
contain the empty string, the ONT
disables the toggle session
operation for the line in question.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or '#'.
An invalid value causes the ONT to
act as if this parameter was not
configured. This parameter only
has meaning if the enable_esti
parameter is set to “yes”. The
default is an empty string.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(16 of 23)