Alcatel-Lucent 7330 - Page 247

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-47
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
etsi_ch_release This parameter contains the value
of the consult call service option
code which is used to drop the
active session and resume held
session as a two-way call ending
the consult state. If this parameter
is not configured or is configured
to contain the empty string, the
ONT disables the functionality.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or '#'.
An invalid value causes the ONT to
act as if this parameter was not
configured. This parameter only
has meaning if the enable_esti
parameter is set to “yes”. The
default is an empty string.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_ch_toggle This parameter contains the value
of the consult call service option
code used to toggle between two
sessions. If this property is not
configured or is configured to
contain the empty string, the ONT
disables this functionality.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or '#'.
An invalid value causes the ONT to
act as if this parameter was not
configured. This parameter only
has meaning if the enable_esti
parameter is set to “yes”. The
default is an empty string.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_ch_merge This parameter contains the value
of the consult call service option
code which is used to merge two
sessions to a 3-way call with mixing
in the ONT. If this property is not
configured or is configured to
contain the empty string, the ONT
disables this functionality.
Valid values are in the form “Rd,
where d represents '0'-'9' or '*' or '#'.
An invalid value causes the ONT to
act as if this parameter was not
configured. This parameter only
has meaning if the enable_esti
parameter is set to “yes”. The
default is an empty string.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(15 of 23)