Alcatel-Lucent 7330 - Page 246

5 — VoIP overview
5-46 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
cfwd_implicit This value controls whether the
voice client will SUBSCRIBE to call
forwarding status NOTIFY
messages or whether the voice
client will expect to receive
NOTIFY messages without a
subscription.
If the value is set to ‘no’, the voice
client subscribes if either of the
cfwd_state or cfwd_reminder
values are set to ‘yes’.
If the value is set to ‘yes’, the
voice client will process NOTIFY
messages without having
performed a SUBSCRIBE.
The default value is ‘no’.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
session_timer_meth
od
This value controls which SIP
method is used for session timer
functionality. The options are
‘update’ or ‘invite’. The default is
‘invite’.
YYPackage
A, B, H
only
No, value is
derived
from
FTP/default
line profile.
N/A
enable_warmline This value controls whether the
warm line feature is enabled.
If the value is set to ‘yes’, warm
line is enabled. When warm line is
enabled, if the permanent_timer
expires before a caller who has
picked up the phone (gone off
hook) dials any digit, the CPE
device sends an INVITE request
using the value specified in the
direct_connect_uri property as the
requested URI.
The default is ‘no’, warm line is
disabled.
As of R4.4, the parameter is
changed to a string value. The
options are:
• True/1/Yes
• False/0/No (default)
• Subscriber
When set to Subscriber, the
subscriber can activate or
deactivate the warmline service
and configure the default
destination number for warmline
calls.
YYPackage
A, B, H
only
Yes TL1 using
DIRCONNECT
set to 0 or 1
using
ent-profile-v
oipappservic
e
CLI using
dir-conn-feat
ure
using
configure
voice ont
voip-app-serv
ice
enable_etsi This parameter controls whether
the ONT acts in accordance with
ETSI or GR requirements for
offering services. A value of “yes”
enables ETSI behavior. The default
is “no”.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(14 of 23)