Alcatel-Lucent 7330 - Page 250

5 — VoIP overview
5-50 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
enable_calling_nam
e_id
This parameter determines
whether a display name is output
to the phone set.
When the parameter is set to ‘yes
(default), the display name is
included as part of the caller ID
output data. When the parameter
is set to ‘no’, the display name is
not i nclud ed as part of the caller ID
output data.
YYAll
except
package
C, D,
and E
Yes TL1 using
CALLERID set
to 2 using
ent-profile-v
oipappservic
e
CLI using
calling-numb
er
using
configure
voice ont
voip-app-serv
ice
callerid_uri_prefere
nce
This parameter specifies whether
to set tel-uri as a higher priority
than sip-uri, when there is more
than one p-assert header present.
Supported parameters are ‘sip’,
‘tel’, or ‘first’. Unsupported values
are mapped to ‘first’. If an
incoming call contains more than
one p-assert header, this
parameter controls which header
is used to populate the caller ID
data output on the phone set.
When the parameter is set to ‘sip’,
the p-assert header that is formed
with a sip-uri will be used. When
the parameter is set to ‘tel’, the
p-assert header that is formed with
a tel-uri will be used. When the
parameter is set to ‘first’
(default), it indicates the p-assert
header that occurs earlier in the
incoming INVITE will be used for
the caller ID data. The default is
‘first’
YYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
add_media_level_cli
ne
This parameter controls the
presence of the second “c-line”, or
contact address, in the SDP for
obsolete hold. This parameter is
ignored when the obsolete_hold
parameter is not enabled. The
options are “yes” (default)
meaning the second c-line will be
added as part of the media
description, and “no”, meaning
only a single session-level c=line is
present in the SDP, and it is set to
0.0.0.0.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(18 of 23)