Alcatel-Lucent 7330 - Page 251

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-51
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
direction_in_hold_r
eq
This parameter controls the value
of direction attribute inserted into
the hold SDP when standard hold
behavior is enabled. This
parameter is ignored when the
obsolete_hold parameter is
enabled. The options are
“sendonly” (default) and
“inactive”, which correspond to
the direction attribute that is used
in SDP for the hold request.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_ch_release_hel
d_call
This parameter contains the
service code to be used to release
the held session during a
consultation call. If this property is
not configured or is configured to
contain the empty string, the ONT
shall disable this functionality.
Valid values shall be of the form
“Rd”, where d represents '0'-'9' or
'*' or '#'. An invalid value will cause
the ONT to act as if this parameter
was not configured. This
parameter only has meaning if the
enable_esti parameter is set to
“yes”. The default is an empty
string.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_activate_call_
waiting
A set of one or more service codes
that the user agent will recognize
as a request to activate call
waiting in ETSI mode. The value of
this property may include up to
two service codes of six characters
each, separated by white space.
This reflects that fact that in
typical dial plans there are two
equivalent ways to dial a given
service code. The default is
“*43#”.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_deactivate_call
_waiting
A set of one or more service codes
that the user agent will recognize
as a request to de-activate call
waiting in ETSI mode. The value of
this property may include up to
two service codes of six characters
each, separated by white space.
This reflects that fact that in
typical dial plans there are two
equivalent ways to dial a given
service code. The default is
“#43#”.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(19 of 23)