Alcatel-Lucent 7330 - Page 252

5 — VoIP overview
5-52 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
etsi_interrogate_cal
l_waiting
A set of one or more service codes
that the user agent will recognize
as a request to interrogate call
waiting active status in ETSI mode.
The value of this property may
include up to two service codes of
six characters each, separated by
white space. This reflects that fact
that in typical dial plans there are
two equivalent ways to dial a given
service code. The default is
“*#43#”.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
ets_ch_release_held
_call
This parameter contains the
service code to be used to release
the held session during a
consultation call. If this parameter
is not configured or is configured
to contain the empty string, the
ONT disables the functionality.
Valid values shall be of the form
“Rd”, where d represents '0'-'9' or
'*' or '#'. An invalid value will cause
the ONT to act as if this parameter
was not configured. This
parameter only has meaning if the
enable_esti parameter is set to
“yes”. The default is an empty
string.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_3wc_split_prec
onf
This parameter contains the
service code to be used to split a
3-way call and return to the
pre-conference state. If this
property is not configured or is
configured to contain the empty
string, the ONT shall disable this
functionality. Valid values shall be
of the form “Rd”, where d
represents '0'-'9' or '*' or '#'. An
invalid value will cause the ONT to
act as if this parameter was not
configured. This parameter only
has meaning if the enable_esti
parameter is set to “yes”. The
default is an empty string.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
enable_call_hold_to
ne
This parameter controls whether
or not the ONT will play the call
hold tone to the user when the
associated RTP session is inactive
or “sendonly”. This parameter only
applies when the enable_esti
parameter is set to “yes”. The
default is “no”
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_recall_dial_ton
e_name
This parameter contains the name
of the tone to be played to indicate
to the user that mid-call dialing is
allowed. Possible values are
“DialTone” or “RecallDialTone”.
This parameter only applies when
the enable_esti parameter is set to
true. The default is
“RecallDialTone”.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(20 of 23)