Alcatel-Lucent 7330 - Page 253

5 — VoIP overview
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 5-53
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
etsi_held_party_ring
back
This parameter shall control
whether or not ringing shall be
applied when a user goes on hook
with an RTP session on hold. This
parameter only applies when the
enable_esti parameter is set to
true. The default is “no”.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_ch_release_earl
iest
Specifies the code used to release
a call and return to a two-way call
by releasing the first added call.
Valid values are in the form Rd,
where d is 0-9, *, or #. The default
is an empty string. You can only
configure the parameter when the
enable_etsi parameter is set to
true.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_ch_release_late
st
Specifies the code used to release
a call and return to a two-way call
by releasing the last added call.
Valid values are in the form Rd,
where d is 0-9, *, or #. The default
is an empty string. You can only
configure the parameter when the
enable_etsi parameter is set to
true.
N Y All
except
package
C, D,
and E
No, default
value is used
in TL1.
N/A
etsi_3wc_release_ea
rliest
Specifies the code used to reduce a
three-way call to a two-way call by
releasing the first added call. Valid
values are in the form Rd, where d
is 0-9, *, or #. The default is an
empty string. You can only
configure the parameter when the
enable_etsi parameter is set to
true.
YYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
etsi_3wc_release_la
test
Specifies the code used to reduce a
three-way call to a two-way call by
releasing the last added call. Valid
values are in the form Rd, where d
is 0-9, *, or #. The default is an
empty string. You can only
configure the parameter when the
enable_etsi parameter is set to
true.
YYAll
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(21 of 23)