Alcatel-Lucent 7330 - Page 254

5 — VoIP overview
5-54 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
enable_3wc_focus Specifies the behavior of the ONT
when generating contact name in
an INVITE of a second call. The
options are:
• true (default)
• false
When set to true, the ONT appends
3WC to the contact name and adds
the isfocus header. If the
three-way call is reduced to a
two-way call, a re-invite is sent to
remove the isfocus.
When set to false, the ONT does
not append 3WC to the contact
name and does not add an isfocus
header to the invite message.
You can configure the parameter
when the enable_etsi parameter is
set to true
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
prefer_early_media Specifies whether to continue to
output early media to a user even
after the ONT receives a 180
ringing response.
The options are:
• True/1/Yes to ignore the 180
ringing response
• (default) False/0/No to
suppress the early media
session and play a local
ringback tone
This parameter is available in XML
releases R4.1 and 4.3, but not
R4.2.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
enable_service_in_r
emote_hold
Specifies whether the ONT
supports supplementary services
such as three-way calling, call hold
display, and call transfer when the
call session is remotely held.
The options are True/1/Yes and
False/0/No. If this parameter is set
to True, then ONT supports the
supplementary services. The
default is False. This attribute is
only supported in XML R4.4 and
later.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
service_code_enabl
e_warm
Specifies the feature access
service code used by subscriber to
activate warmline. The user agent
must support at least two service
codes, as is typical in most dialing
plans. The default is *53*. This
reflects that fact You can
configure the parameter when the
enable_warmline parameter is set
to Subscriber.
N Y All
except
package
C, D,
and E
No, value is
derived
from
FTP/default
line profile.
N/A
Parameter Description Mode
1
Mode
2
Device OMCIv2
support?
TL1 or CLI
parameters
(22 of 23)