Alcatel-Lucent 7330 - Page 273

6 — ONT management using an ONT interface
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 6-5
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
Security
The HTTP and CLI interfaces are password-protected to prevent unauthorized access
to utilities. In addition, each ONT has a security setting that specifies the access level
of a user to the HTTP and CLI interface utilities, after the ONT is ranged. User access
levels are as follows:
• read-write access, which grants a user read and write access to all utilities
• read-only access, which grants a user read-only access to the SLID, ranging state,
and RSSI of the ONT
• no access, which denies a user access to all utilities
HTTP interface
The HTTP interface is GUI-based. Figure 6-1 shows a sample HTTP interface, with
the main parts of the interface labeled. The following sections describe these parts.
Note 1 — Contact the CO for the level of access that has been set for
a specific ONT.
Note 2 — The HTTP and CLI interfaces require a specific username
and password. Contact your Alcatel-Lucent technical support
representative for username and password information.
Note 3 — The following exceptions apply to security.
• If the PON is out of service, you have read-only access to the
SLID, ranging state, and RSSI of the ONT, regardless of the access
level of the ONT.
• If the ONT or the Ethernet port on the ONT is out of service, you
cannot log in to the ONT using the HTTP or CLI interface.