Alcatel-Lucent 7330 - Page 279

6 — ONT management using an ONT interface
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 6-11
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
6.4 Accessing or disconnecting from the HTTP or a CLI interface
This section shows you how to:
• access the HTTP or a CLI interface
• disconnect from the HTTP or a CLI interface
Prerequisites
The prerequisites are:
• The ONT is installed.
• The ONT is in service.
• For an indoor ONT, the first Ethernet port, which is typically labeled 1 on the
ONT, is in service.
• For an outdoor ONT, the ONT has a serial RS-232 craft interface.
• For an indoor Package C ONT, the ONT has an Ethernet port in service.
Procedures using HTTP interface
The HTTP interface is accessible through the first Ethernet port on an indoor ONT
using a computer or laptop with an HTTP client. The ONT must support an HTTP
server, and the computer must have a supported HTTP client (Web browser).
The following procedures provide the steps to access and to disconnect from the
HTTP interface using the first Ethernet port.
Activating an
ONT using an
SLID
To view current
SLID settings
To view current
SLID settings
To view current
SLID settings
To retrieve the
current SLID
settings
—
To clear the SLID To clear the SLID ——To clear the SLID
using a butt set
To enter the
SLID
To enter the
SLID
To enter the
SLID
To modify the
SLID
To enter the
SLID using a butt
set
Task Procedure using
HTTP interface
Procedure using
CLI interface
Procedure using
Package C ONT
HTTP interface
Procedure using
Package C ONT
CLI interface
Procedure using
butt set
(2 of 2)
Note — Contact your Alcatel-Lucent technical support
representative for a list of supported Web browsers.