6 — ONT management using an ONT interface
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 6-65
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
3 Press Enter.
4 If necessary, reboot the ONT (Procedure 6-28) in order for the new SLID to take
effect immediately.
5 STOP. This procedure is complete.
Procedures using butt set
The following procedures provide the steps to clear the SLID and to enter a SLID at
the ONT using a butt set.
Procedure 6-48 To clear the SLID using a butt set
1 Ensure that the ONT is disconnected from the PON optical cable.
2 Reboot the ONT.
3 Connect the butt set to the first POTS port on the ONT.
4 Wait for the green POTS LED on the ONT to start flashing (one second on, and two
seconds off).
5 Take the butt set off-hook.
6 Dial “*1#” to convert the permanent SLID to a volatile SLID.
When the ONT is powered off and on, the SLID is reset to its default value.
7 Power the ONT off and on to reset SLID to its default value.
8 Take the butt set on-hook to exit.
9 STOP. This procedure is complete.
Procedure 6-49 To enter the SLID using a butt set
1 Ensure that the ONT is disconnected from the PON optical cable.
2 Connect the butt set to the first POTS port on the ONT.
3 Wait for the green POTS LED on the ONT to start flashing (one second on, and two
seconds off).
4 Take the butt set off-hook.
Note — To use a butt set:
• The ONT must be disconnected from the PON optical cable.
• The butt set must be connected to the first POTS port on the ONT.
• The SLID must be in decimal or hexadecimal format.
To Next Page
Loading...
