6 — ONT management using an ONT interface
6-66 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
5 Perform one of the following to activate the dial tone:
a For a volatile decimal SLID, dial “*”:
b For a volatile hexadecimal SLID, dial “0*”.
c For a permanent decimal SLID:
• Dial “9* to deliver the SLID to the P-OLT using the proprietary PLOAM
message.
• Dial “8*” to deliver the SLID to the P-OLT using the password PLOAM
message defined in G.984.3
d For a permanent hexadecimal SLID:
• Dial “90* to deliver the SLID to the P-OLT using the proprietary PLOAM
message.
• Dial “80*” to deliver the SLID to the P-OLT using the password PLOAM
message defined in G.984.3
The dial tone is activated.
6 After the dial tone is activated, perform one of the following to dial the SLID
value:
a For a decimal SLID, dial the SLID value up to 10 digits long.
b For a hexadecimal SLID, dial the SLID value up to 20 digits long. Only digits
in the range 0 to 9 are accepted.
7 Dial “#” to send the SLID number to the ONT.
The ONT exits the SLID input mode and enters the SLID output mode, and sends
confirmation tone and SLID number. If a hexadecimal SLID is less than 20 digits,
the ONT automatically appends zeroes to the end of the SLID.
8 Verify that the SLID was entered correctly.
To Next Page
Loading...
