EasyManua.ls Logo

Alcatel-Lucent 7330 - Page 351

Alcatel-Lucent 7330
420 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7 — B-0404-A unit data sheet
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 7-9
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
G.984.3 support for multicast using a single GEM Port-ID for all video traffic
G984.4 (standard and revised) support for OMCI interface for ONT management
and provisioning
7.11 B-0404-A special considerations
Do not submerge the B-0404-A business ONT. The device cannot withstand water
submersion caused by flooding. Equipment damage will occur.
The B-0404-A E1 interface supports standard 120 Ω termination via an RJ-48C.
Customers that require a 75 Ω termination need an external adapter.
Line loopbacks are not supported.
The B-0404-A does not support VLAN translation and VLAN pass-through traffic
that uses the same p-bit across the same UNI or downstream p-bit translation when
services are configured in VLAN pass-through mode.
Upgrade considerations and limitations
Existing ONTs that use 7342 ISAM FTTU releases older than R04.06.xx and
R04.07.xx must be upgraded to use R04.00.10 software while assigned to a PON ID
value smaller than 64. For this purpose, if split ratios larger than 1:64 are being
deployed, you may choose to set aside the first PON ID as a staging point.
B-0404-A ONT hardware limitations
Table 7-10 lists the hardware limitations for the B-0404-A business ONT when
configuring services.
Table 7-10 B-0404-A business ONT hardware limitations
Limitation Parameters
(1)
Service
B-0404-A ONT must be enabled for port-to-port
communication to support the flexible mode. In this
communication mode, a business service can only be
configured on port 1, and the service is replicated on the
other enabled ONT UNI ports.
proftype
p2penable
QoS
ONT
The following are not supported:
both VLAN translation and VLAN pass-through on traffic
using the same p-bit across the same UNI
VLAN translation when networksidevlan is 4096 and
unisidevlan is 0 to 4094. Upstream traffic is classified
and forwarded as pass-through traffic. Downstream
traffic is not translated to the unisidevlan setting.
unisidevlan HSI
networksidevlan Flow
(1 of 2)

Table of Contents

Other manuals for Alcatel-Lucent 7330

Related product manuals