7 — B-0404-A unit data sheet
7-10 March 2011 Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a
ONT Product Information Guide Edition 01 3FE 54199 AAAA TCZZA
Note
(1)
See 7342 ISAM FTTU Operations and Maintenance Procedures Guide using TL1 and CLI for
information on these parameters.
Downstream p-bit translation is not supported when the
flow is configured for VLAN pass-through. In this case, the
following applies:
• a flow with networksidevlan 4096 and unisidevlan 4096,
will pass downstream p-bits to the UNI unchanged
• a flow with networksidevlan and unisidevlan set to the
same value (0 to 4094), will pass downstream p-bits to
the UNI changed to the highest p-bit value specified by
the PQ profile
When all of the following apply, the highest UNI-side p-bit
value defined in the p-bit translation profile is used:
• unisidevlan is 0 to 4094 and networksidevlan is 0 to
4094, or unisidevlan is 4096 and networksidevlan is
4096
• pbitxlprofid/nm is not 0
• p-bit translation is not defined for the downstream
p-bit in the p-bit translation profile
unisidevlan HSI
networksidevlan Flow
pbitxlprofid
pbitxlpofnm
Limitation Parameters
(1)
Service
(2 of 2)
To Next Page
Loading...
