NTP 101 — Replace a B-0404-A
Alcatel-Lucent 7330/7302 ISAM FTTN R04.02.42a March 2011 NTP 101-5
3FE 54199 AAAA TCZZA Edition 01 ONT Product Information Guide
9 If used, configure the SLID (DLP 122).
10 If required, have approved service personnel who are trained to work with optic
fiber clean the fiber optic connection. See DLP 127 for more information about
fiber optic handling, inspection, and cleaning.
11 Connect the fiber optic cable.
i Plug the OptiTap adaptor into the fiber optic port (DLP 117).
ii Plug the SC/APC adaptor into the fiber optic port (DLP 118).
12 Verify the ONT LEDs and voltage status (DLP 120).
13 Activate and test the services (DLP 121).
14 STOP. This procedure is complete.
Note — A new SLID or the old SLID may be used with the replacement
unit. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT.
Danger — Fiber optic cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
To Next Page
Loading...
