OmniAccess 4504, 4604, and 4704 WLAN Switch | Installation Guide Installation | 15
Tabletop Deployment
To deploy an OmniAccess 4504, 4604, or 4704 switch on a flat surface, such as a tabletop:
1. Insert the four, rubber mounting feet into the bottom of the unit and place the unit on a flat, hard
surface.
Initial Setup and Network Connectivity
Once the physical installation is complete, run the initial setup on the switch to configure the IP address
and other basic system information. For complete details and instructions, refer to the AOS-W Quick
Start Guide for the software version installed on your switch.
Removal
To remove an OmniAccess 4504, 4604, or 4704 switch from a 19-inch (48.26 cm) rack system:
1. Disconnect power to the switch by unplugging the power cord from the electrical outlet.
2. Loosen and remove the four rack system mount screws securing the switch to your organization’s
rack system.
3. Remove the switch from the rack system.
To Next Page
Loading...
Need help?
General
