Managing OmniSwitch 6250 Stacks OmniSwitch 6250 Stacking Specifications
OmniSwitch 6250 Hardware Users Guide June 2012 page 6-3
OmniSwitch 6250 Stacking Specifications
The following table lists OmniSwitch 6250 Stacking specifications.
Changing Stacking Mode on Metro Models
The OmniSwitch 6250 Metro Models non-combo fiber ports can be set to either stackable or standalone
mode. By default the mode is set to standalone but can be changed in order to support stacking. After
changing the mode the switch must be rebooted.
The following example shows how to change the mode to stackable using the stack set slot mode
command.
-> stack set slot 1 mode stackable reload
Note. The HDMI stacking cables do not contain a locking mechanism. To avoid loose connections, ensure
they are firmly seated.
Models Supporting Stacking All (Metro and Enterprise switches cannot be mixed in the
same stack)
Maximum Switches in a Stack Enterprise Platforms - 8
Metro Platforms - 2
Stacking Cable Lengths
(HDMI and SFP+ Copper
30cm
60cm
150cm
To Next Page
Loading...
