Connecting Chassis to Power Source Mounting OS6250 Switches
page 3-26 OmniSwitch 6250 Hardware Users Guide June 2012
Connecting Chassis to Power Source
AC Power Supply Connections
Since the power cord is the switch’s only disconnect device, it should be plugged into an easily accessible
outlet. In the event that your power cord is lost or damaged, refer to the specifications below.
Powering On a Chassis
Follow the steps below to power on the chassis using and AC power source:
1 Connect the IEC-60320-C15 end of the supplied power cord to the primary and optional redundant
power supply.
2 Install the cord retainer bracket to the back of each installed power supply bracket using the attach-
ment screws (provided). Place the slotted retainer clip over the bracket with the retainer fingers pointing
down and slide the retainer bracket toward the power supply until it meets the power cord connector.
Insert two screws (provided) into the retainer clip slots and tighten until secure.
3 Connect primary and optional redundant power supplies to AC power source.
4 Monitor the chassis as it boots.
Retainer bracket Slotted retainer clip Secured Power Cord
To Next Page
Loading...
