Monitoring the Chassis Booting 6250 Switches
page 4-6 OmniSwitch 6250 Hardware Users Guide June 2012
Checking the Fan Status
To check the current status for all six fans in the chassis, use the show fan command. For example:
-> show fan
Chassis Fan Status
-------+---+-----------
1 1 Running
1 2 Running
1 3 Running
1 4 Running
For a complete list of output definitions for this command, refer to the OmniSwitch CLI Reference Guide.
Checking the Power Supply Status
For information on checking power supplies for OmniSwitch 6250 switches, refer to “Booting 6250
Switches” on page 4-1.
Additional Monitoring Commands
CLI Commands Used for Monitoring a Chassis
show cmm Displays the basic hardware and status information for primary and
secondary management modules (if applicable).
show ni Displays the basic hardware and status information for individual mod-
ules. If the switch is a standalone, information for the stand alone
switch displays.
show module Displays the basic information for individual modules. If the switch is a
standalone, information for the stand-alone switch displays.
show module long Displays the detailed information for individual modules. If the switch
is a standalone, information for the standalone switch displays.
show module status Displays the basic status information for individual modules. If the
switch is a standalone, information for the standalone switch displays.
To Next Page
Loading...
