Mounting OS6250 Switches Mounting OS6250 Switches
page 3-16 OmniSwitch 6250 Hardware Users Guide June 2012
5 Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each
flange. Tighten both screws until they are secure.
Rack-mounting Chassis with Power Supply Tray (OS6250-RM-19)
Rack-mounting Two Chassis (OS6250-DUAL-MNT)
Note. Be sure to install the screws in the bottom hole of each flange, as shown, before proceeding.
6 Once the screws at the bottom of each flange are secure, install the remaining two rack mount screws.
Be sure that all screws are securely tightened.
When rack mounting, a
clearance of 0.875 inches is
recommended above the
chassis.
No minimum clearance is required below the chassis
assembly. However, be sure that the bottom of the chassis
is not in direct contact with any equipment below.
When rack mounting, a clearance of
0.875 inches is recommended above
the chassis.
No minimum clearance is required below the chassis
assembly. However, be sure that the bottom of the chassis
is not in direct contact with any equipment below.
To Next Page
Loading...
