Chapter 
1
General Presentation
1.1 Preliminary
1.1.1 Document summary
This document contains installation and cabling procedures of racks, boards, phone sets and interface
modules.  It  also  explains  startup  procedures  for  OXO  Connect  and  phone  sets,  along  with  safety
information and conformance with directives, and basic maintenance operations.
This  document  only  describes  the  features  supported  by  OXO  Connect  RC2.0*  (for  example:  MMC
station  is  not  described  since  it  is  not  supported).  Please  refer  to  the  OXO  Connect  Documentation
Note,  for  historical  information.  In  addition,  the  Cross  Compatibility  document  is  the  reference  for
detailed status about supported and unsupported devices and applications.
* RC2.0 stands for any release starting from 2016 introducing Connect capabilities.
It appears on:
• Product stickers with release format: RC020/xx.yy
• In any documentation (including this one) as: R2.0
1.1.2 Symbols used IN the documentation
 See note.
 See important information.
1.1.3 Clauses
Copyright and Trademarks
Datalight is a registered trademark of Datalight,Inc.
FlashFXtm is a trademark of Datalight, Inc.
Outlook is either a registered trademark, or a trademark of Microsoft Corporation in the United States
and/or other countries
Copyright 2001 - 2016 Datalight, Inc., All Rights Reserved.
1.2 Protection against Interferences
Notice to the attention of the users and installer:
USA - FCC (Federal Communication Commission)
This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a  Class  B  digital  device,
pursuant  to  part  15  of  the  FCC  Rules.  These  limits  are  designed  to  provide  reasonable  protection
against  harmful  interference  in  a  residential  installation.  This  equipment  generates,  uses  and  can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
3EH21123USAA - Ed. 01  - April 2017 - Installation Manual 10/207