5. Enter the administrator password, then press OK to confirm the reset to factory, or press Cancel to
cancel the reset.
• If the password is WRONG or Cancel is pressed; the set displays again the reset screen, the
choice selector is set to NO: without further action, the set will go on with normal startup.
• If the password is VALID, you are prompted to confirm the action:
6. Press Yes to confirm the reset to factory: reset to factory is performed and the set restarts
immediately.
Press No to cancel: the set displays again the reset screen, the choice selector is set to NO: without
further action, the set will go on with normal startup.
4.4.3 4135 IP Conference Phone
4.4.3.1 Commissioning
4.4.3.1.1 Overview
This module presents all the actions required for commissioning 4135 IP Conference Phone sets.
Chapter
4
Installation and Cabling
3EH21123USAA - Ed. 01 - April 2017 - Installation Manual 87/207
To Next Page
Loading...
