Installation
17
− Only connect the appliance to a properly installed earthed mains socket if the
water inlet and outlet have been connected correctly (see next chapter). The
socket must have a fuse rated at min. 10 ampere.
− The mains plug must remain easily accessible after installing the appliance.
Water connection
NOTICE!
Damage to the appliance!
If the appliance is connected improperly, there is a risk of damage
to the appliance.
− Do not shorten or damage the supply hose. There is a risk of
short-circuiting due to live parts.
− The hose must be free of kinks and connected carefully.
− Connect the water supply hose to a cold water tap with 3/4“
thread. You can also connect the supply hose to a hot water
tap if the water temperature does not exceed 60°C.
This reduces wash time by about 15 minutes.
− Screw the hose connection hand tight.
The water hose is designed for a water pressure of approx.
10 bar. We recommend closing the water supply off after use,
especially if your house connection does not have a pressure
reducer.
NOTICE!
Material damage!
Material damage is possible in the event of water leakage.
− Turn off the water supply again after use to avoid water
leakage in the event of a damaged hose.
To Next Page
Loading...
Need help?
General
