Operating the dishwasher
29
Program
Suitable for
Sequence
Detergent (main wash/
prewash)
Duration (h:mm)
Energy consumption
[kWh]
Water consumption [l]
Rinse aid
Glass
Glass
Items with light
dirt such as
glasses, porcelain
Main wash (45°C)
Wash
Wash (60°C)
Dry
18 g 1:15 0.5 7 Yes
90 min.
90 min
Dishes and glasses
with light dirt
Main wash
(65°C)
Wash (70°C)
Dry
18 g 1:30 0.65 7 Yes
Quick
Rapid
Items with light
dirt that do not
have to be dried
Main wash
(40°C)
Wash
Wash (40°C)
15 g 0:30 0.23 6 No
* The ECO program is the standard program for cleaning dishes with normal dirt and
is the most effi cient in relation to the combined energy and water consumption. The
ECO program is used for the test operation according to EN 50242.
Position 6 is recommended as rinse aid setting.
Operating the dishwasher
Proceed as follows to operate the appliance:
Plug the mains plug into a 220–240 V ~ 50 Hz socket. The fuse/circuit breaker must
be protected with at least 10 ampere. Turn on the water supply fully.
Open the appliance then load it and prepare for operation as described above.
Add the detergent, rinse aid and possibly salt, depending on the desired program.
Close the door.
Switch on the appliance by pressing the ON/OFF
1
button.
To Next Page
Loading...
