Operating the dishwasher
31
Open the door slightly to interrupt the programme. Wait about 3 seconds until the
spray arm stops rotating and then open the door completely.
The appliance emits an acoustic signal every minute if the door is open
during operation.
Load the additional dishes and/or remove items.
Close the door and press the START/PAUSE button to continue the program. The
program continues after approx. 10 seconds.
Using start preselection
You can start the wash program at a later time via a delay. Select between 1 and 24
hours for the start delay.
− Switch on the appliance by pressing the ON/OFF
1
button.
The display shows the remaining time left for the set program to run.
− Press the PROGRAM
7
button several times to select a program. The
corresponding program symbol lights up in the display.
− Press the TIME DELAY
8
button several times until the corresponding time is
shown in hours in the display
(H:01 = 1 h, H:02 = 2h, ... , H24= 24 h start delay).
− Press the START/PAUSE
6
button.
The appliance starts automatically after the set delay time.
End of the wash program
CAUTION!
Risk of burning!
Hot water/hot steam can escape and cause burns if the door is
opened while a program is running.
− Do not open the door immediately – wait instead until the
appliance has cooled down.
To Next Page
Loading...
