Troubleshooting
36
Troubleshooting
Technical faults
The appliance does
not start.
Fuse defective or circuit
breaker tripped
Change the fuse or switch
on the circuit breaker again.
Make sure that the electric
circuit is protected with at least
10 ampere.
Appliance is not switched
on
Switch the appliance on.
Door of the appliance is
not fully closed.
Close the door correctly.
Water was not
pumped out of the
dishwasher.
Water outlet hose is
kinked.
Route the hose so that it is not
kinked.
Filter blocked Clean the fi lter regularly.
Water outlet hose blocked. Check the water outlet hose.
Make sure the water outlet hose
is properly installed.
General faults
Foam in the appliance Incorrect detergent Only use detergent that
is suitable for household
dishwashers.
If foam has formed, open the
appliance and wait a while until
the foam has disappeared. Start
the “Quick” wash cycle without
detergent to remove detergent
residues.
Spilled rinse aid Remove the rinse aid
immediately.
Blotched appliance
accessories
Detergent with additives
was used.
Only use detergent without
colour additives.
White deposits inside
the appliance
Mains water hard/high in
calcium carbonate
Clean the appliance with a little
cleaner for dishwashers using
a damp sponge. Wear rubber
gloves during cleaning.
Always use only cleaners for
household dishwashers.
Rust marks on the
cutlery
The cutlery in question is
not stainless.
To Next Page
Loading...
