Preparations for use
20
− Remove the dish rack and twist the lid off the regeneration salt container.
− Fill the regeneration salt container with 700 ml water before the fi rst use.
− Then add 1 kg dishwasher salt. It is normal if a small amount of water escapes
from the regeneration salt container.
− Once the container has been fi lled, twist the lid clockwise and closed.
− To avoid damage to the appliance, a wash program should be started directly
after fi lling (see “Selectingthe program” on page 28).
Depending on how quickly the salt dissolves in the water, it may be the case
that the salt display
3
remains lit after the salt has been added.
The regeneration salt container usually only has to be replenished if the salt display
lights up.
If there are salt residues in the appliance, start a quick program to rinse these out.
Setting salt consumption
− Set the required salt consumption, depending on the local water hardness.
− The table below shows what setting is necessary for your local water hardness.
Ask your water utility about the water hardness.
Water hardness
Salt consumption
Press –/+
Display
dH
(degree of German
hardness)
mmol/l
(Millimole per litre)
0–5 0–0.9 1 x H1
6–11 1.0–2.0 2 x H2
12–17 2.1–3.0 3 x H3
18–22 3.1–4.0 4 x (factory setting) H4
23–34 4.1–6.1 5 x H5
35–45 6.2–8.0 6 x H6
− Close the appliance door.
− Press and hold the START/PAUSE
6
button for about 5 seconds to reach setting
mode.
− Press the START/PAUSE button several times to set the salt consumption
according to the table above.
To Next Page
Loading...
