Cleaning and maintenance
34
− To protect the control panel too, make sure that no moisture comes into contact
with the electronics. Do not use spray cleaner!
− The spray arm inside the appliance can be removed to clean it. Lift this slightly
and remove it. Clean the spray arm under running water and make sure the
openings are not blocked. Reinstall it again afterwards.
Cleaning the water inlet fi lter
A fi lter is located inside the water supply connection
17
.
− Unscrew the hose nut with sealing ring.
− Remove the fi lter using pliers and clean it. Reinstall the fi lter after cleaning.
− Fasten the hose on the water supply connection using the hose nut. Tighten
the hose nut. Make sure that the sealing rings fi t correctly and that the screw
connection is not tilted.
The aqua stop connection also contains a fi lter.
− Remove the hose connection from the cold water tap.
− Remove the sealing ring with sieve e.g. using a small Philips screwdriver.
− Clean the screen under running water. Use a little limescale remover in case of
heavy calcifi cation.
To Next Page
Loading...
