ALERTON MICROSET 4 - Page 48

INSTALLATION & OPERATIONS GUIDE | MICROSET 4
© Honeywell LT-MS4IOG Rev. 04 | Revised October 2015
48
AI-object properties
Applies to AI-0 only since that is the only analog input object in the Microset 4.
AV-object properties
BV-object properties
PROPERTY ACCESS NOTES
Object Identifier R
Object Name R/W AI-0.
Object Type R
Present Value R/W Value handled as described in the sequence of operation
Description R/W
Status Flags R All false
Event State R NORMAL
Out Of Service R FALSE
Units R
PROPERTY ACCESS NOTES
Object Identifier R
Object Name R/W “AV-nnn” by default.
Object Type R
Present Value R/W As described below
Description R/W
Status Flags R No flags set
Event State R Normal
Out Of Service R FALSE
Units R As described below
PROPERTY ACCESS NOTES
Object Identifier R
Object Name R/W “BV-nnn” for most BVs by default.
Object Type R
Present Value R/W As described below
Description R/W
Status Flags R No flags set
Event State R NORMAL
Out Of Service R FALSE
Priority Array R/W BV-40 only
Relinquish Default R/W BV-40 only