5.2 Normal operation 5 Operating Instructions
5.2.2 Start
1.
Start of separator:
a.
Open the water supply valve.
b.
Start the separator by pushing the start
button at the starter unit.
N
O
T
E
After every start the separator must always be run
continuously for a minimum of 1 hour to ensure
proper lubrication. Try to learn the vibration
characteristics d uring the critical speeds.
R
O
I
G08717c1
2.
Check the separator for vibration.
!
W
A
R
N
I
N
G
Excessive vibration
If vibration increases, or continues at full speed, keep
bowl filled and stop the separator.
The cause of the vibration must be determined and
corrected before starting again! Excessive vibration
may be due to incorrect assembly or insufficient
cleaning of the bowl.
G0871881
N
O
T
E
Normal vibration
Vibration may occur during start up when passing
critical speed. This is normal an d should pass witho ut
danger.
34
To Next Page
Loading...
