Alinco DJ-A41 - Advanced Operations; Call 1;Call 2 DTMF; Monitor; Momentary Monitor

Professional
FM Transceiver
16
ADVANCED OPERATIONS
The [PF1] and [PF2] keys are programmable by dealer to assign following features by using
programming software.
NOTE: When programming the following functions, you need to press the [PF1] / [PF2] key for one
second till the transceiver beeps and then release the key to operate the programmed function.
Call 1/Call 2 DTMF
Under the standby conditions, press the programmed key to transmit the prestored and selected
DTMF signaling.
Monitor
Under the standby conditions, pressing and releasing the programmed key, it beeps and enters the
monitor state. While in Monitor, it ignores CTCSS / DCS decode and enables monitoring all incoming
signals. Press this key again, it beeps twice and exits the monitor state.
Momentary Monitor
Under the standby conditions, pressing and holding the programmed key, it beeps and enters the
monitor state. While in Monitor, it ignores CTCSS / DCS decode and enables monitoring all incoming
signals. Press this key again, it beeps twice and exits the monitor state.