Professional
FM Transceiver
17
ADVANCED OPERATIONS
Temporary Deletion of the Interfering Channel from scanning
This function can temporarily skip the interfering channel or occupied channel from scan list.
When scan stops on one channel, pressing the programmed key ; it beeps and temporarily deletes
this channel from the scan list. If only one or two channels are in the scan list, this operation is not
available. Restart the transceiver to restore the temporarily deleted channels into the list again.
Squelch Levels Enquiry
Under the standby conditions, pressing and holding the programmed key, it will announce current
squelch level by voice.
Squelch Levels Setup
Under the standby conditions, pressing and holding the programmed key, it will set the squelch and
announces the level by voice.
Scan
Scan function is to automatically search the busy channels.
Under the standby conditions, pressing and holding the programmed key, a beep sounds and starts
scanning. It scans channels in scan list one by one. When one channel receives a matching signal,
the transceiver will temporarily stay in this channel till the signal disappears. Pressing the key again,
it beeps twice, and stops scanning and returns to the channel pre-programmed as "return-channel".
To Next Page
Loading...
