Rockwell Automation Publication 1734-UM013N-EN-P - September 2017 113
Chapter 6
Configure the Module for a SmartGuard
Controller
This chapter provides information about how to configure a SmartGuard™
controller and POINT Guard I/O™ modules by using USB (Universal Serial Bus)
connectivity. See the corresponding RSNetWorx™ for DeviceNet software help
files for network-configurator operating procedures.
Topic Page
Before You Begin 114
Set the Node Address 114
Auto-addressing with a 1734-PDN Adapter 116
Set Up Your DeviceNet Network 118
Configure the POINT Guard I/O Modules 119
Configure the SmartGuard Controller 128
Save and Download Module Configuration 133
For information about RSNetWorx for DeviceNet software, from the Help
menu, choose RSNetWorx Help.
To Next Page
Loading...
