50 Rockwell Automation Publication 2100-IN012G-EN-P - August 2016
Chapter 4 Installing and Removing Plug-in Units
Remove a SecureConnect
Unit from a Section
To remove a SecureConnect™ unit from a section, follow these steps.
1. Make sure the disconnect handle is in the OFF/O position.
2. Slide the shaft port cover open.
3. Insert the 1/4 in. hex tool into the shaft port.
4. Rotate the wrench counter-clockwise to retract the power stabs.
The indicator next to the disconnect handle changes from red to green.
5. Pull out the power stabs lockout lever.
You can attach a lock to the lever to prevent the lever from being pushed
in and the power stabs being extended.
6. Remove the cover from the status port.
Shaft Port
Open Closed
Shaft-port Cover
Indicator
To Next Page
Loading...
