Rockwell Automation Publication 2100-IN012G-EN-P - August 2016 55
Installing and Removing Plug-in Units Chapter 4
7. Remove other cables or devices that can prevent the unit from being
withdrawn.
.
8. Pull the unit forward (outward) approximately 3 in. (7.5 cm) out of the
MCC by using the handle provided at the lower left of the unit and the
tab in the upper right of the unit as finger holds.
Reposition your hands, as necessary, to properly support the unit while
you are removing the unit from the MCC.
TIP It is not necessary to place wires and terminal blocks into the vertical
wireway to remove a plug-in unit that includes the wiring clearance tunnel.
ATTENTION: Plug-in MCC units can be heavy or awkward to handle. Use an
assistant or a platform lift device, if necessary, to help you handle the unit.
To Next Page
Loading...
