Rockwell Automation Publication DNET-IN001B-EN-P - January 2012 35
Install a 1769 DeviceNet Communication Module Chapter 2
5. On the Device Selection dialog box, check the ‘I want to input the address
for the device on the selected network’ box.
6. Browse to the DeviceNet network.
7. Type the current address for the device. Out of the box, devices use
address 63.
8. Click OK.
9. When you return to the Node Commissioning dialog box, enter the new
address for the device.
10. Click Apply.
11. Look for confirmation in the Messages area.
To Next Page
Loading...
